Dakota Alert Wireless Driveway Alarm System - Specifications

Wireless Sensor Specifications

• Frequency: 433.92 MHz
• Operating range: -30?F to 110?F
• Battery life: 6-12 months
• Reset time: 15 seconds
• Power Source: 9V (9V Battery Not Included)
• Operating Temperature Range: -30°F to 110°F
• Wireless Range: 600 feet*

Wireless Receiver Specifications

• Frequency: 433.92 MHz
• Operating voltage: 12VDC
• 12 volt DC output current: 400 mA maximum
• Relay output rating: 24VDC at 3 Amp

Dakota Alert Wireless Driveway Alarm System - Included

• 1 - Dakota Alert Wireless Motion Transmitter
• 1 - Dakota Alert Wireless 3000 Receiver
• 1 - 12V Power Supply for Receiver

Replaced by the new Dakota DCMA2500

The Wireless Motion Drive Alert 3000 uses an Infra Red Sensor to detect people and cars. It has a wireless range of an incredible 600' with a built in chime, timed relay output and many other advanced features! The WMA-3000 is the next step in the evolution of the wireless infrared driveway alarm. We have taken our years of experience and created the ultimate in wireless systems.

The transmitter operates on one 9 volt battery and is easily mounted on a tree or post near the drive. The transmitter uses a passive infrared (PIR) beam to detect people or vehicles out to about 80 feet then send a radio signal back to the WR-3000 receiver up to 600’ away*. The outdoor sensor and transmitter is weatherproof and meant for exterior locations. Up to 4 zones can be monitored with additional transmitters. The transmitters can be programmed so they will each sound a different tone at the receiver.

The WR-3000 is the receiver for the WMA-3000 system. The WR-3000 plugs in to a standard wall outlet and can be placed on a table or mounted on the wall. When the receiver gets a signal from the transmitter one of 4 different tones (Classical, Westminster Chime, Ding Dong, Whistle) will sound for a few seconds. There is also a volume control so you can set the sound to the desired level. The receiver comes equipped with 4 form “C“ relays (one for each zone) and one 12 VDC output terminal that will activate for several seconds when an alarm signal is received. The receiver can be user programmed so the 12VDC terminal and one relay will activate for 1 or 10 minutes if this is desired. The tones will still sound for several seconds.

Dakota Alert Wireless Driveway Alarm System - Support and Downloads

• Dakota Alert Receiver Manual
• Dakota Alert Wireless Driveway Sensor