Door Alarm Motion Sensor and Chime Receiver
The Dakota Alert indoor motion sensor can be used a security motion sensor for rooms, offices etc. or as a commercial door alarm when mounted to face the entrance. With a wireless range of up to 600 feet* and full compatibility with any of the Dakota Alert 3000 Series transmitters or receivers, the IR-3000 will allow you to monitor many indoor locations that were difficult before. The passive infra red detector is able to monitor an area up to 100º wide. With the integral mask, the detection area can be narrowed down to 20º or anywhere in between. With the swivel mount, the IR-3000 sensor can be adjusted right to left up to 80º and up and down up to 50º. With three different sensitivity settings, the IR-3000 can detect a person up to 12 feet, 25 feet or 40 feet away. The sensor can also be set to flash an LED or stay dark when a signal is sent. The IR-3000 is powered by one 9 volt battery and will have a battery life of about 12 months under normal conditions. There is also a low battery alert to notify you when it is time to replace the battery. The IR-3000 is designed for indoor or light duty outdoor applications under an eave or awning or other protected location.
The WR-3000 wireless receiver plugs into any standard wall outlet and can be placed on a table or mounted on the wall. When the receiver gets a signal from one of the transmitters, one of 4 different tones (Classical, Westminster Chime, Ding Dong, Whistle) will sound for a few seconds. There is also a volume control so you can set the sound to the desired level. The receiver comes equipped with 4 form "C" relays (one for each zone) and one 12 VDC output terminal that will activate for 10 minutes when a signal is received. The receiver can be user programmed so the 12VDC terminal and one relay will activate for 1 to 10 minutes if this is required. The musical tones will not be affected by this timer.
Wireless Driveway Alarms
Homesaver Alarm
