Digital Timer allows your Driveway Alarm system
to turn on your lights automatically for a set amount of time.

Universal Digital Programmable Timer Operation Instructions

1. Move the two PowerFlash slide switches to match the image.
2. Connect the LTU timer to the X-10 PowerFlash by tightening the Timer’s spade tips under the screw terminals on the Power Flash as shown in the image.
3. Connect your Driveway Alarm using the guide below

Optex RC10. Connect the NO and COM terminals on the back of the RC10 to terminals 2 and 3. Polarity does not matter.

AutoAlert AL155. Connect the output of the accessory jack on the side of the AL155 to terminals 1 and 2. White stripe (neg) goes to 2 .

Mier Drive Alert Connect the red and black terminals on the back of the receiver to terminals 2 and 3. Red to 3 and Black to 2.

MURS Alert. Connect the red and black terminals on the back of the 538 base station to terminals 2 and 3. Polarity does not matter.

Dakota Drive Alerts (IR, probe and hose). Connect the NO and NEG screw terminals on the controller to terminals 1 and 2. NO to 1 and NEG to 2.

To set the Timer duration force the timer in to program mode by bending out and using the paper clip to press and hold the reset button until the light flashes. This will take about 10 seconds.

The time value may now be entered by pressing and releasing the reset button up to 10 times. Each press of the button increments the timer length as indicated in the table below. After 30 seconds, the programming mode is terminated and the LED indicator will flash once for each press of the reset button to confirm the timer value selected. If the reset button was never pressed, then the last value for the timer will stay in tact and there will be no flashes from the LED. The timer can be programmed before connecting the unit to the PowerFlash.