Alert Zones |
| Number of Zones: |
4 or 8 (2.8K thermistor comes installed on zone 1 for temperature monitoring) |
| Zone Connector: |
Terminal block |
| Zone Types: |
N. O. / N. C. contact, 2.8K thermistor (-20° F to 150° F or -30° C to 65° C ) |
| Zone Characteristics: |
5.11K to 2.85V (Short circuit current: 1mA max.) |
| A/D Converter Resolution: |
10 bits ±2 LSB |
| Zone Protection: |
5.5VDC Metal Oxide Varistor with fast acting diode clamps. |
Built in Microphone |
| Internal Electret Condenser: |
For listening in to on-site sounds and detecting high sound levels. |
Phone Interface |
| Line RJ11 Jack: |
For connection to a two-wire analog telephone line. (6’ modular cord included) |
| Extension RJ11 Jack w/ Line Seizure: |
For connecting other devices on the same telephone line, devices connected to this jack are disconnected in the event that the 800 must dial out for an alarm. |
| Phone Line Protection: |
Metal Oxide Varistor & self-resetting fuse |
LED Indicator |
| System On: |
On steady when the unit is in RUN mode. LED blinks once every few seconds while in STANDBY mode. |
| Phone In Use: |
On steady when the telephone line is being used. LED blinks when no dial tone is detected. Off when telephone line is not in use. |
| Alarm: |
Off when no alarm exists. Blinks when an unacknowledged alarm exists. On steady when an acknowledged alarm exists |
| Battery Ok: |
On steady when the battery is in good condition. Blinks when the battery is low. Off when the battery must be replaced. |
Relay Output |
| Rating: |
Rated for 1A 30VAC/1A 30VDC maximum. |
Power Supply |
| Power Supply: |
120VAC/9VDC 60Hz 6W wall plug-in transformer w/6’ cord. |
| Power Consumption: |
1.5 Watts |
| Power Protection: |
Metal Oxide Varistor |
| Battery Backup: |
Six size-C alkaline batteries (not included), providing up to 24 hours of back-up time. |
Environmental |
| Operating Temperature: |
32–122° F (0–50° C) |
| Operating Humidity: |
0–90% RH non-condensing |
| Storage Temperature: |
32°–140° F (0–60° C) |